Machine Settings - Zanussi ZTE 273 Notice D'utilisation

Discoloration

Machine settings

Setting
Alarme (Buzzer) permanent off
Water hardness
Water contains, a variable quantity
of limestone and mineral salts of
which quantities vary according to
geographical locations thus vary-
ing its conductivity values.
Relevant variations of the conduc-
tivity of the water compared to
those prefixed by the factory could
slightly influence the residual hu-
midity of the laundry at the end of
the cycle. Your dryer allows you to
regulate the sensitivity of the dry-
ing sensor based on conductivity
values of the water.
Laundry insufficiently spun.
Particularly high room temperature.
Temporary switching off of the com-
pressor to avoid overload.
Colour fastness of textiles.
1. Turn the programme selector to any programme.
2. Press simultaneously the Délicat (Delicate) and Anti-Froissage (Long An-
ticrease) buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off.
1. Turn the programme selector to any programme.
2. Press simultaneously the Anti-Froissage (Long Anticrease) and Marche/
Arrêt (Start/Pause) buttons and hold down for approx. 5 seconds. Lights
show the current setting:
– Bac plein (Water Reservoir) - low conductivity <300 micro S/cm
– Filtres (Filter) - medium conductivity 300-600 micro S/cm
– Condenseur (Condenser) - high conductivity >600 micro S/cm
3. Press the Marche/Arrêt (Start/Pause) button sequentially until you set
desired level.
4. To memorize setting press simultaneously the the Anti-Froissage (Long
Anticrease) and Marche/Arrêt (Start/Pause) buttons or turn knob to OFF
off
position
Laundry must be adequately spun.
Automatic process, there is no fault
with the appliance. If possible, lower
the room temperature.
Check colour fastness of textiles. Only
treat textiles together if they are a sim-
ilar colour.
Implementation
13