Workplace - Steba WP 110 Mode D'emploi

∙ If a GS-tested 16 A multi-pin extension is used, it may not be
charged with more than 3680 watts due to fire hazard.
∙ Make sure that children do not tease the cable or that a trip
hazard occurs.
∙ The device must always be disconnected from the power supply
if it is not supervised and before assembling, disassembling or
cleaning.
Cleaning
Attention! Pull the plug before cleaning and allow
∙
the device to cool down.
∙ Never immerse the unit into water.
∙ Clean the device with a damp cloth.
∙ Do not use aggressive or abrasive cleaning agents.

Workplace

Important:
Never place this device on or next to hot surfaces (e.g. hot stoves). Only use it on a
even, stable and a heat resisting surface. It is important that no inflammable items
are near to the device. Do not place the device on the edge of the table so that it
cannot be touched by children or fall down when touched.
General
∙ The device is suitable for keeping plates and terrines with food warm.
∙ The ceramic heating stone in the device is heat up in about 10 minutes to 100°C in
the centre of the plate. After the device is heated up, it can be used disconnected
from the power supply on a table. Within one hour, the surface temperature drops
to about 50°C.
Operation
∙ Connect the power cord.
∙ Switch on the device, the red lamp lights up and the appliance starts to heat.
∙ After reaching the temperature of approx. 100°C, the red lamp turns of and the
green one lights up.
∙ If the device is kept on the power supply, the thermostat clocks. The red and green
lamp light up alternately.
∙ If the device is turned off, or is operated without the power cord, the temperature
drops to approx. 50°C within one hour.
9