Peak-Value Memory; Sensorteach - HBM PACEline CMD600 Manuel D'emploi

CMD600

3.6.5 Peak-value memory

The analog output values Min/Max peak and Peak/Peak value can be stored
in the charge amplifier and output via software or the analog output. The peak
values can be deleted via the digital input (DIGITAL I/O connector, PIN 4) or
the software.

3.6.6 SensorTeach

SensorTeach is an additional function for automatic scaling of the charge
amplifier.
During auto-scaling, the amplification is set so that the applied loads
correspond to an output signal of 10V minus the set overload limit in Volt. This
function can be implemented via the CMD Assistant and/or via the digital input
(SYSTEM connector, PIN 2).
NOTE
The SensorTeach function must be enabled in the Assistant (Enable scaling
SensorTeach
There are two possibilities of automatic scaling:
1. Scaling with the maximum value via the digital input − without the
CMD600 Assistant
− Apply the supply voltage of 24V to PIN 2 of the SYSTEM socket then
remove it (after approx. 1 sec.) .
− The amplifier switches to the 600,000 pC range, resets the signal input and
the output to the set output offset.
− The LED display on the CMD600 flashes yellow slowly (1 Hz).
− Load sensor and remove load (the maximum value is determined).
− End measurement by applying +24V to Pin 2 again.
− The control in the amplifier selects the maximum value.
*)
1. When the input signal lies in the range 6000 − 600,000 pC,
the amplification is set and the scaling is therefore implemented.
− The amplification is set to 10V less the set overload limit, the LED stops
flashing and lights up green.
A2781−2.1 en/de/fr
).
19