Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
3.2. PREPARING FOR USE
3.2.1. APPLIANCE LOCATION
The temperature of environment must not be higher than
40°C and the relative humidity should be less than 85%.
Ensure good ventilation in the room in which the device
is being used. There should be at least 10 cm distance
between each side of the device and the wall or other
objects. Keep the product away from hot surfaces. The
device should always be used when positioned on an
even, stable, clean, fireproof and dry surface, and be out
of the reach of children and persons with limited mental
and sensory functions. Position the device such that you
always have access to the power plug. The power cord
connected to the appliance must be properly grounded
and correspond to the technical details on the product
label.
3.2.2. BEFORE FIRST USE
Remove the packaging from the machine and its
components. Clean all accessories (see section 3.5.
Cleaning and maintenance). Wipe dry with a soft cloth.
3.2.3. ASSEMBLING THE DEVICE
1.
Before use, install the spacer (marked in the figure)
under the air outlet. Apply glue (provided) to the
screw heads of the spacer and attach the spacer to
the unit.
2.
Before use, insert the drip tray.
3.
Install the following accessories depending on the
intended use of the appliance:
•
Installing the spit
10
•
Assemble the basket
•
Assemble the spit
NOTE: It is recommended to only use the spit with the
rotation function (3.4.2).
NOTE: Use the provided handle to safely insert and remove
the spit.
3.3. OPERATION MODES
NOTE: Temperature and time can be adjusted in each
operating mode
Rev. 17.01.2022
Operation modes
Temperature [°C]
Time [min]
FRIES
220
25
FROZEN POOD
80
10
WINGS
200
15
DEHYDRATE
50
480
STEAK
180
12
CHIPS
220
20
FISH
180
15
VEGETABLES
180
12
10 (the
program takes
POPCORN
220
2 minutes to
heat up)
CHICKEN
220
30
CAKE
180
30
SKEWER
200
15
PIZZA
180
15
KEEP WARM
80
30
TOAST
200
4
COOKIE
180
12
3.4. DEVICE USE
3.4.1. HOW TO USE YOUR AIRFRYER
1.
After connecting the device to power supply, an
acoustic signal will sound. The display and the
operation indicators will start flashing, then the screen
will turn off.
2.
When you press the „ON / OFF" button, the indicator
light comes on and the device enters standby mode.
3.
In standby mode, the following buttons are active:
„ON / OFF", „MENU", „PRESET".
NOTE: The device in standby mode will automatically
turn off in 60 seconds if no operation is performed.
4.
Keep pressing the „MENU" button until you select
the operating mode (temperature and time can be
adjusted in each operating mode) and confirm by
pressing the „ON / OFF" button. The device will enter
the selected operation mode. A second press of the
„ON / OFF" button cancels the selected settings.
5.
In order to change the temperature or time, select
the „TEMP"
or „TIME"
button accordingly. To
increase or decrease the value, select the „+" or „-"
button.
Rev. 17.01.2022
EN
NOTE: Pressing the „-" or „+" button changes the
temperature by 10 ° C and the time by 1 minute.
NOTE: Pressing and holding the „-" or „+" button
changes the time by 10 minutes. The time range is
1-60 minutes (except for the drying function which is
8 hours).
6.
When the device stops working, it will produce an
acoustic signal. The fan runs for 1 minute after the
operation is finished. Wear protective gloves and be
careful when taking the food out of the appliance.
After use, press the „ON / OFF" button and pull out
the mains plug.
3.4.2. THE FUNCTIONS
DELAY START FUNCTION
1.
Press the „PRESENT" button
, the display will
show the default time of 1 hour, use the „+" and „-"
buttons to set your preferred time (the time range is
from 1 min to 9h 59min). Wait until the set value stops
flashing.
2.
Then keep pressing the „Menu" button until the
operating mode is selected and confirm with the „ON/
OFF" button.
3.
The device will switch to the set operating mode after
the set time is counted down.
PAUSE
If the appliance door is opened during cooking, the
appliance will pause automatically. If the door is not closed
after 10 minutes, the machine will stop working and turn off.
NOTE: The buttons active during a pause are „ON / OFF"
and „ROTISSERIE"
ROTATION FUNCTION
•
Install the drip tray and the spit with the food into the
appliance.
•
Press the button
and the machine will start turning
the spit. Press the button
again to deactivate the
rotation function.
NOTE: the maximum weight of the food must not
exceed 5.95 kg.
3.5. CLEANING AND MAINTENANCE
a)
Unplug the mains plug and allow the device to cool
completely before each cleaning, adjustment or
replacement of accessories, or if the device is not
being used.
b)
Use only non-corrosive cleaners to clean the surface.
c)
Use only mild, food-safe detergents to wash the
device.
d)
After cleaning the device, all parts should be dried
completely before using it again.
e)
Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
f)
Do not spray the device with a water jet or submerge
it in water.
g)
Do not allow water to get inside the device through
vents in the housing of the device.
h)
Clean the vents with a brush and compressed air.
i)
The device must be regularly inspected to check its
technical efficiency and spot any damage.
j)
Use a soft, damp cloth for cleaning.
k)
Do not use sharp and/or metal objects for cleaning
(e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
11
Publicité
Table des Matières
