Laserworld Ecoline Série Mode D'emploi page 5

8.2. Music mode, Sound-to-light operation
Your device runs in music mode:
Control the music-sensitivity with the trim pot at the back panel. The LED is flas-
hing when the device is triggered.
8.3. DMX-512 mode
Switch 10 must be set to „off", the other switches are used for setting the DMX
address:
Connect a DMX controller to operate the laser.
Use the switches 1 - 9 to set the DMX address of the laser. Each switch represents a
number. To define a number use the preceding number and multiply it by 2:
Switch 1 2 3 4 5
Number 1 2 4 8 16
The laser uses 12 DMX channels, so make sure that the next device uses an address
that doesn't overlap with this range.
Channel Value
1 0 - 69
70 - 139
140 - 209
210 - 255
2 0 - 255
3 0 - 255
4 0 - 255
5 0 - 255
6 0 - 255
6 7 8 9 10
32 64 128 256 Mode Switch
Function
Laser off
Sound mode
Automatic mode
DMX mode
Pattern selection
Strobe effect
Point speed
x axis positioning
y axis positioning
Channel Value
7 0 - 255
8 0- 255
9 above 200
10 1 - 255
11 1 - 255
12 1 - 255
Please note that a pattern can not necessarily be combined with each effect.
8.4. Turn laser off
To turn off the device switch it off („OFF"), switch the key to „OFF" and disconnect
the power cable from the mains.
Function
Zoom / size
Color
Reset
Rotate x axis
Rotate y axis
Rotate z axis