Device Connections; Warnings And Other Notices On The Device - Laserworld Ecoline Série Mode D'emploi

-
Do not face spotlights (especially
moving heads) to the device.
- Check temperature after approx.
30 minutes with each new ins-
tallation. If necessary install the
projector at a place with different
temperature.
-
Switch off device when it is not
needed. Diodes are switched on
and can wear out even if there is
no visible laser output.
- Keep the device dry. Protect it
from moisture, rain and damp.
• The devices of Ecoline, Evolution,
Club and Proline Series are not
meant for professional applica-
tions. After approx. one hour of

6. Warnings and other notices on the device

Laser radiation!
Avoid exposure
to beam
Laser class 3B
Caution of ra-
diation if cover
is removed
Use in enclosed spaces only!
operation, the device should cool
down for about 15 minutes.
• Please ensure the fans and
heatsinks are clear from dust and
debris otherwise the risk of over-
heating may occur. If the unit and
airways appear to be blocked then
please contact a qualified service
engineer to maintain and service
the product.
• Removal of the warranty label
as well as damages to the device
caused by improper handling,
neglect of the safety instruc-
tions and service notes will void
the warranty.
Model type
Production year
Wavelength
Output power
Power supply
& consumption

7. Device connections

Laser aperture
warning label
DMX address,
operation mode
LED:
Sound sensitivity
microphone
DMX out DMX in
8. Operation
a. Connect the power cable to the device and then to the mains
b. Insert the key into the key switch and turn it „ON"
c. Connect the Interlock Connector with the Interlock interface
d. Press „ON" to switch the device on
8.1. Automatic, Stand-alone operation
Set the device to auto mode:
LED:
Laser emission
trim pot for
music-sensitivity
ON/OFF switch
mains connection
key switch
Interlock