Care & Maintenance; Warranty - Fortress Building Products V Série Instructions D'installation

CARE & MAINTENANCE
Care And Maintenance Of Fortress Building Products
Powder-Coated Products And Surfaces:
• Immediately after installation of your Fortress Building
Products, clean powder-coated products and surfaces with a
solution of warm water and non-abrasive, pH neutral
detergent solution. Surfaces should be thoroughly rinsed after
cleaning to remove all residues. All surfaces should be cleaned
using a soft cloth or sponge.
• Ensure construction materials such as concrete, plaster, and
paint splashes are removed immediately before they have a
chance to dry. Failure to remove these materials may cause
damage to the powder-coated surfaces.
• The frequency of cleaning depends in part on the standard
of appearance and also the requirements to remove deposits
that may cause damage to the powder coating after
prolonged exposure. Fortress recommends cleaning in three to
four monthly intervals all products and powder-coated
surfaces. In areas where higher traffic, increased atmospheric
substances, or other effects may occur, the time period
between cleanings should be increased to monthly intervals.
• WARNING: DO NOT use strong solvents such as thinners, or
solutions containing chlorinated hydrocarbons, esters, or
ketones. Abrasive cleaners or cutting compounds should not
be used.

WARRANTY

To obtain and review a copy of the warranty, please go to:
https://Fortressbp.com/warranties. You can also contact:
(844) 909-1999 or write to: Fortress Building Products Warranty,
1720 N 1st St, Garland, TX 75040 to obtain a copy of the warranty.
V-SERIES: VERTICAL CABLE INSTALLATION
37