Fortress Building Products V Série Instructions D'installation page 11

Note:
• Measure from the back wall of the bracket to the back wall
of the bracket on other post. As shown in Fig. 2 below.
Fig. 1
Measure the panel opening
Check measurement with top
CUTTING DOWN PANELS
Step 1: Measure & Mark Rails Where Cuts Will Be Made
1. To ensure rails are symmetrical, take the measurement
found in step 3 above, and divide it in half. Then cut equal
lengths from both ends.
2. Find the center of the rails and measure out half of the
length each direction. As shown in Fig. 1 below.
3. Mark these locations with a pencil on the top and
bottom rail.
Fig. 1
Mark Here
Half of Panel Length
Mark Here
Step 2: Cut & Clean Rails
1. Cut rails using a saw with a ferrous metal cutting blade.
2. Use file to smooth cut edges.
3. Remove any metal shavings and dust with a brush or rag.
Center of Rails
V-SERIES: VERTICAL CABLE INSTALLATION
Fig. 2
Mark Here
Mark Here
DO NOT
measure from
post
Measure
from back
of bracket
11