Fortress Building Products V Série Instructions D'installation page 20

2. Pre-drill bracket holes with a 3/16" [5mm] drill bit.
As shown in Fig. 2 below.
3. Remove the bolt from the Angle Bracket Assembly.
Fig. 1
Step 3: Install UB-05 Angle Adapter
1. Dis-assemble the UB-05 bracket Adapter & Cup.
2. Attach Angle Adapter Base piece to the posts with supplied
T-25 thread-cutting screws. Use low speed setting on drill.
As shown in Fig. 1 below.
3. Assemble the UB-05 Adapter by tightening the Barrel &
Screw. As shown in Fig. 2 below.
4. Attach UB-05 Cup to Angle Adapter using Phillips Head
Thread-Cutting Screws. As shown in Fig. 3.
Tip:
• Use a Bit Extender for an easier drilling process.
Fig. 1
20
V-SERIES: VERTICAL CABLE INSTALLATION
Fig. 2
1-3/16"
[30mm]
Fig. 2
Pre-Drill
with a 3/16"
[5mm]drill bit