Assembly Of The Appliance; Before The First Use - Fritel BBQ 2246 Mode D'emploi

• Repairs may only be done by a recognized repairer or service center.
• ALWAYS place the appliance on a heat-proof, solid and flat base, such as a kitchen counter or table, or on the
support frame (for outdoor use), so that the appliance will not move or turn over.
• NEVER place the appliance near curtains, wall decoration, clothing, towels or other inflammable objects.
• NEVER place inflammable or heat conductive objects on the baking plate, such as a (paper) towel, cutlery, ...
• This appliance is NOT suited for preparing flambé dishes.
• This appliance is NOT suited for use with charcoal or other fuels.
• NEVER pour cold water on the baking plate.
• Leave at least 0,5 m free space around the appliance and 1 m free height in order to avoid damage caused by grease
splashes or heat and in order to work unhindered.

2. ASSEMBLY OF THE APPLIANCE

When assembling the appliance, make sure the power cord is unplugged.
a) Baking plate
For a safe use, it is very important that the plate is correctly placed on the grill holder.
• Take the baking plate with both hands.
• Place the baking tray with the opening for excess cooking grease/fluids directly above the opening to the fat
collecting tray (on the rear side of the appliance) on the grill holder.
• To remove the baking plate again, simply pull it upwards.
CAUTION: Only remove the baking plate when it has entirely cooled off or place it on a heat-resistant table mat.
TIP: The device can be used both as a table grill and as a BBQ (see point d) The support frame).
b) The grease collecting tray
Place the grease collecting tray in the frame. The appliance may NEVER be used without grease collecting tray.
c) The windshield
For outdoor use, the windshield must also be mounted on the grill holder:
• Place the sides of the windshield on the left and right side of the baking plate.
• Push the rear side of the windshield into the two holders on the back of the baking plate, from top to bottom.
d) The support frame
The grill can also be used on the support frame as a BBQ appliance. This must be mounted as follows:
• Insert one of the legs through one of the openings of the enclosed shelf for platters, from the bottom to the top.
• Push the leg into the provided hole in the supplied support frame.
• Attach the leg by inserting one of the supplied screws through the provided hole and fix it on the inside with a wing
nut.
• Mount the other three legs in the same way on the support frame.
• Then secure the shelf for platters to each leg by inserting the supplied screws through the provided hole and fix it on
the inside with a wing nut.
• Place the grill on the support frame and make sure it "clicks" into the frame.
IMPORTANT: Make sure the appliance is securely mounted on the support frame before plugging in.

3. BEFORE THE FIRST USE

• Check if the mains voltage of your appliance (230 Volt) corresponds with the mains voltage in your home.
• Remove all packaging and stickers.
• Keep the packing material out of reach of children.
• Clean the appliance as described under point 7. Cleaning and maintenance.
• All parts must be completely dry!
17