In Case Of Problems; Problems And Solutions - switel DF 100 Série Mode D'emploi

In Case of Problems

Registering handsets
Before starting to register a handset, switch the base station to Registration mode. Press
and hold the Paging button on the base station until you hear an acoustic signal. The
base station is then in Registration mode for the following 60 seconds. Continue with the
handset.
2 sec. ‘
Now register the handset . Page 72. The currently valid PIN code is used for registra-
tion purposes; . Page 71.
The handset is automatically assigned an internal call number following registration.
To register handsets from other manufacturers, please refer to the operating
manual supplied with them.
Deregistering handsets
Each handset can be used to deregister other handsets registered on this
base station.
Handsets are deregistered via the menu. Refer to Page 72 for the sequence of menu op-
tion selections.
Multiple base stations
You can increase the range of your handset by registering it on several base stations.
The handset can be registered on up to 4 different base stations simultaneously. Each
base station requires its own telephone line socket. Connections can be used with the
same call number or with different ones.
Calls in progress cannot be transferred from one base station to another.
13 In Case of Problems
Service Hotline
Should problems arise with the telephone, please refer to the following information first.
In the case of technical problems, you can contact our hotline service, Tel. 0900 00 1675
within Switzerland (Swisscom fees at time of going to print: CHF 2.60/min). In the case
of claims under the terms of guarantee, please contact your sales outlet. There is a 2
year period of guarantee.

Problems and solutions

Problems
No connection to base station poss-
ible
76
Activate Registration mode
Solutions
− Check that the handset has been regis-
tered on the base station with the correct
PIN code; . Page 71.
Problems Solutions
No telephone calls possible − The telephone is not connected properly or
is defective. Only use the telephone con-
nection cable supplied.
− Test whether the telephone connection is in
order by using another telephone.
− The power adaptor plug is not plugged in
or there is a complete power failure.
− The rechargeable battery pack is empty or
defect.
− The handset is too far from the base sta-
tion.
− The wrong dialling mode is set;
. Page 71.
Connection is disturbed or cut off − The handset is too far from the base sta-
tion.
− The base station is in an unsuitable loca-
tion.
The system no longer responds − Return all the functions to their default
status using the Master Reset" function;
. Page 71.
− Disconnect the power adapter plug briefly
from the power socket.
The rechargeable batteries are − The rechargeable batteries are empty or
empty in a short time defect.
− Place the handset in the base station
properly. Clean the contact surfaces on the
handset and base station with a soft, dry
cloth.
− Place the handset in the base station for
15 hours.
1
The caller number display (CLIP ) − The caller number display (CLIP) is a sup-
does not function plementary service offered by your tele-
phone network provider. Contact your net-
work provider for further information.
− The caller has suppressed the trans-
mission of their phone number.
1
CLIP: Calling Line Identification Presentation = Displays the caller's phone number.