Sigma EM-140 DG Mode D'emploi page 18

◆ Ready light lamp will light, and the AF Auxiliary lamp will blink to indicate that the flash is ready for
shooting.
12. Adjust the focus on the subject, and take the picture.
It is also possible to use High Speed Synchro photography. After the above-mentioned setting please set
flash of controller as High Speed Synchro. Please refer to High Speed Synchro photography section for
more details.
When triggering both CONTROLLER and OFF-CAMERA FLASH.
Controller Setting
1. Attach the Flash to the camera.
2. Press the MODE button to select the
3. Press SEL button, to make the channel indicator blink on the display.
4. Press + or – button to set the desired channel number.
5. Press SEL button to make the indicator stop blinking.
Off-Camera Flash Setting
6. Press the MODE button to Select the
7. Press SEL button, to make the channel indicator blink on the display.
8. Press + or – button to choose the same channel number as on
the controller.
9. Press the SEL button several times until blinking stops.
10. Place the off-camera flash at the desired position.
11. Check that both flashes are fully charged.
◆ Ready lights will be lit and the AF Auxiliary lamp will blink, to indicate that the flash is ready for shooting.
12. Adjust the focus on the subject and take the picture.
It is also possible to use High Speed Synchro photography. After the above-mentioned setting please set
flash of controller as High Speed Synchro. Please refer to High Speed Synchro photography section for
more details.
It is also possible to set the maximum flash output amount of the controller by 1/2, 1/4 or 1/8.
1. Press the SEL button several times to make the flash output
amount indicator blink.
2. Press the + button or – button to set the flash output amount.
3. Press the SEL button several times to make the display stop
blinking.
SPECIFICATIONS
Guide Number : 14 ISO 100/m (when the flash is fired at full power)
Power Source : AA Alkaline Battery or AA NiCd Battery or AA Ni-Mh Battery x 4pcs
Recycling Time : about 6.0 sec. (Alkaline batteries)
: about 4.0 sec. (Ni-Cd, Ni-MH Nickel-Metal Hydride)
Angle of Coverage : Vertical / Horizontal 80 degrees
Weight : 430g (without batteries)
Dimensions (Controller) : 76.7mm×136.2mm×82.4mm
Dimensions (Flash Unit) : 126.6mm×128.8mm×30.5mm
17
mark.
⁄ mark.