Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Step 7:
Installation of the footrests (98) at footrest holder (45).
1.
Push the right footrest (98R) onto the right footrest holder (45R). Adjust
the holes in the parts so that they are aligned.
2.
Push the carriage bolts M6x45 (94) from above through the holes. Put
on a washer (96) from the opposite side and screw on Handgrip nut
(97) and tighten firmly.
3.
Install the left footrest (98L) on the left footrest holder (45L) as descri-
bed in 1. – 2. (Note: The right and left footrests (98) can discern by
the edges of the longitudinal sides of the footrests. The high edges
of the footrests (98) must point inwards (towards the main frame. The
position adjusted in this way should always be equal at both sides. The
positions can change as desired at all times by removing the carriage
bolts (94) and sliding the footrests on the footrest brackets to get a
more or less flat movement.)
Step 8:
Attach the computer (1) at support (3).
1.
Put the plug of connection cable (2) into the plug from computer (1)
backside.
2.
Insert the plug of pulse cables (51) to the jacks of the computer (1)
and attach the computer (1) to top monitor bracket of support (3) with
screws (67). Use screws from backside of computer. (Attention: Ensure
that the cable loom are not crunched or pinched during installation.)
3.
Mount computer cover set (37+38) to the support (3) and secure with
screws (31+35).
Step 9:
Checks
1.
Check the correct installation and function of all screwed and plug
connections.
Installation is thereby complete.
2.
When everything is in order, familiarise yourself with the machine at a
low resistance setting and make your individual adjustments.
Note:
Please keep the tool set and the instructions in a safe place as these may
be required for repairs or spare parts orders becoming necessary later.
23
Publicité
Table des Matières
