Christopeit Sport NAXXOS ENERGY Notice De Montage Et D'utilisation page 20

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the
floor and check that all are there on the basis of the assembling steps.
Please note that a number of parts have been connected directly to
the main frame and preassembled. In addition, there are several other
individual parts that have been attached to separate units. This will
make it easier and quicker for you to assemble the equipment. As-
sembly time approx. 60min.
Step 1:
Attach the stabilizer (93+72) at main frame (19).
1. Attach the front foot (93) with preassembled transportation roller (92) to
the main frame (19). Do this with the two screws M8x20 (11), washers
(14) and spring washers (12).
2. Attach the rear foot (72) with preassembled height adjustable screw (99)
to the main frame (19). Do this with the two screws (11), washers (14)
and spring washers (12).
After assembly has been completed, you can compensate for minor
irregularities in the floor by turning the foot screw (99). The equipment
should be set up that the equipment does not move of its own accord
during a training session.
Step 2:
Connection of cables (2+18) and assembly of support (3) at the main
frame (19).
1. Place screws M8x20 (11), washers and curved washers (13+14) and
spring washers (12) accessibly beside the front part of the main frame
(19).
2. Place the lower end of the support (3) against the main frame (19) and
push the plastic cover (16) onto the support (3). Plug the ends of the
two computer cable harnesses (2+18) projecting from (3+19) together.
(Note: The computer cable harness (2) projecting from the support (3)
must not slide into the tube, as it is required for later steps of installation.)
When joining the tubes, ensure that the cable connection will not
trapped.
3. Put one spring washer (12) and one washer (14) or curved washer (13) on
each screw (11). Push the screws (11) through the holes in the support
(3), screw into the threaded holes of the main frame (19) and tighten
firmly. Push the support cover (16) into right position.
20