Italiana Camini POINT PLUS Installation, Usage Et Maintenance page 29

E
D
F
C
A
C
g. 1
X
D
X
X
X
g. 2
D
M
C
L
g. 3
V
g. 5
ASSEMBLY
D
F
C
B
C
C
C
D
M
S
C
g. 4
V
CASING
The stove is delivered with metallic sides (A-B) and the metal-
lic brackets for xing the ceramic side elements (D) already
tted. The pieces indicated below are packaged separately.
• 4 ceramic front side elements (C)
• 1 ceramic top insert (E)
• 2 dowels for the ceramic top insert (F)
• 8 M4 screws with milled heads (X)
• 8 washers Ø 4
To t proceed as follows:
Fig. 1/2/3
Remove the two metallic brackets xing the stove's ceramic side ele-
ments (D) by sliding them from the bottom upwards, about 3 cm.
Apply metallic brackets (D) onto the back of the ceramic front
side elements (C), xing them into the holes provided using the
M4 screws and the washers Ø 4 (provided).
Fig. 3/4
Fit the ceramic sides elements (C) (complete with metallic
brackets) from above moving them downwards into the slot (L)
on the square elements of the metallic side (M).
Fig. 5/6/7
Check the vertical alignment of the ceramic side elements (C)
and make any necessary adjustments with the screws above the
top (V - g. 5) and inside the stove with the screws (R - g. 6/7)
N.B. Before carrying out this operation, remove the galva-
nised panel (Z - g. 6/7) on both sides and loosen the locking
screws (T - g. 6/7).
Fig. 4/8
Apply the two dowels (F) onto the lower side of the ceramic top
insert (E), screwing them into the holes provided.
Position the ceramic top insert, tting the dowels into the holes
(S) provided on the metallic brackets (D) installed previously.
left side
R
T
Z
g. 6
F
g. 8
- 29
-
right side
R
T
Z
g. 7
E
F