Storage; Troubleshooting - Profi Cook PC-UM 1086 Mode D'emploi

WARNING:
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
• The blades on the knife block are very sharp. A risk of injury ex-
ists!
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The individual parts are not dishwasher-safe.
NOTE: Preliminary Cleaning
Half fill the mixing vessel with water and turn the
switch to "P" for approximately 10 seconds. Then
pour out the liquid.
For thorough cleaning, please remove the mixing
vessel.
Fitting and detaching the knife block
For this, also refer to figure A on page 3.
1. Turn the mixing vessel on its head.
2. Use moderate force to screw off the locking
ring of the blade unit by turning it towards the
UNLOCK marking.
3. Take the knife block carefully out of the mixing
vessel.
4. Remove the seal ring for cleaning.
5. Place the dry seal ring onto the glass on the
bottom of the turned mixing jar.
6. Place the blade unit onto the seal ring.
7. Insert the locking ring and tighten it by turning it
towards the LOCK marking.
8. Ensure that the knife block sits securely in posi-
tion.
CAUTION:
Only operate the appliance if you have properly
fitted the knife block with the seal ring! Otherwise
the mixing vessel will not be sealed.
40
Mixing jar, lid, measuring cup, locking ring,
blade unit, and seal ring
Clean these parts in a bowl of hot water. Then dry
everything before assembling the parts again.
Housing
Only a moderately moist cloth should be used for
cleaning the outside of the device.

Storage

• Clean the device as described. Let the acces-
sories dry completely.
• You may wind the mains cable at the bottom of
the appliance.
• We recommend that you store the device in its
original packaging when it is not to be used for a
longer period.
• Always store the device at a well ventilated and
dry place outside the reach of children.

Troubleshooting

Device is not working.
Remedy:
• Check the mains connection.
• Check the position of the rotary switch.
Other possible causes:
The device is fitted with a safety switch. This pre-
vents the motor from starting up unintentionally.
Remedy:
Check that the mixing vessel is firmly in place.