Promise Technology VTrak E-Class E830f Guide De Démarrage Rapide page 27

3. Type the new IP Address.
4. Follow the same procedure to specify the Subnet Mask, Gateway IP
Address and DNS Server IP Address.
If you do not have a DNS server, skip the DNS Server IP address.
5. Press Ctrl-A to save your settings.
Making Virtual Management Port Settings – DHCP
DHCP is supported under IPv4 only.
To let your DHCP server make the settings:
1. Press the arrow keys to highlight DHCP .
Press the spacebar to toggle to Enable.
2.
3. Press Ctrl-A to save these settings.
Verifying Your Settings
To verify settings under DHCP:
1. Press the arrow keys to highlight DHCP .
2. Press the spacebar to toggle to Disable .
The current Management Port settings are displayed.
Press the spacebar to toggle DHCP back to Enable .
3.
4. Press Ctrl-A to save these settings and move to the RAID configuration
screen.
Making Maintenance Mode Settings – Manually
To make settings manually:
1. From the CLU Main Menu, highlight Network Management and press Enter.
2. Highlight Maintenance Mode Network Configuration and press Enter.
3. Highlight the controller you want and press Enter.
Highlight DHCP and press the spacebar to toggle to Disabled .
4.
5. Highlight each of the following and press the backspace key to erase the
current value, then type the new value.
• IP Address
• Subnet Mask
• Default Gateway IP Address
• DNS Server IP Address
6. Press Ctrl-A to save your settings.
Task 7: Setting up the Management Ports
27