Table des Matières
Publicité
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• This unit requires iBox Universal Plus rough
01850181.
• The rough must be installed and the finished wall
surface must be complete and made watertight
before installation of this unit.
• The Quattro Green insures that the total flow rate
of the showerhead does not exceed 2.5 GPM
(9.5 L/min) at any setting. It does not permit the use
of two functions simultaneously.
• The trim kit for the Quattro Green is sold separately.
• There are no controls on the Raindance E. The
spray functions are controlled by the Quattro Green
diverter.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
max. 2.5 GPM (9.5 L/min)
• Hansgrohe also recommends iBox Universal plus
01850181 with a thermostatic mixing valve trim and
volume control valve 15977181 with matching trim.
Valves and trims are specified and sold separately.
• To prevent scald injury, the maximum output
temperature of the shower valve should be no
higher than 120°F (49° C). In Massachusetts, the
maximum output temperature of the shower valve
can be no higher than 112°F (44° C).
• This showerhead is for use with automatic
compensating valves rated at 2.0 GPM (7.6 L/min)
or less.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
Table des Matières
