Jumpking JumpPOD jk1331 Manuel De L'utilisateur page 17

4. Lay the Frame Pad (12) on the frame. Adjust the
position of the Frame Pad so the notches are
aligned with the Legs (6) as shown. Be sure
8 Enclosure Frame Openings are t to the
Enclosure Socket position.
Make sure the Velcro tapes to stick tightly.
Securely Tie the four frame pads together using
the attached Elastic Straps.
Do not use the trampoline without the Frame
Pad (12), which is designed to reduce the likeli-
hood of injury to the user from coming in con-
tact with the trampoline frame. If you do not
have a Frame Pad, contact your dealer to
obtain one. Properly install the Frame Pad
before using the trampoline.
5. Look under the trampoline and locate the pairs of
straps attached to the underside of the Frame Pad
(12). Note that some pairs of straps are near the
frame and other pairs of straps are near the edge
of the Bed (13). Position each outer pair of straps
so one strap is on each side of the frame as
shown. Position each inner pair of straps so one
strap is on each side of the nearest Spring ( 5 ) as
shown.
Do not overtighten the straps.
See the inset drawing.
Repeat this step with the remaining straps (not
shown).
6. Thread one end of Elastic Tie-Down, then tie a knot
on V-Ring.
Repeat this step with the remaining straps which at
middle position of each pad section (not shown).
4
Elastic Strap
Notches
5
Cross the strap over the toprail frame to hook the V ring
6
Elastic Tie-Down
V-Ring
Spring
17
Enclosure Frame Opening
12
5
12
13
Strap with "S" hook on the pad edge
Elastic Tie-Down
V-Ring
6