Assembly - Jumpking JumpPOD jk1331 Manuel De L'utilisateur

ASSEMBLY

IMPORTANT ASSEMBLY INFORMATION
• A Phillips Head screw driver is needed to
assemble trampoline/enclosure. However, a
screwdriver is not provided.
• Assembly requires two or three persons. Keep
children away from the trampoline/enclosure
until it is fully assembled.
• Use gloves to protect your hands from pinch
points during assembly.
• The assembly steps refer to parts by their descrip-
tions and key numbers (see the PART LIST on
page 22). If a part is missing, see ORDERING
REPLACEMENT PARTS on page 22.
TRAMPOLINE/ENCLOSURE PLACEMENT
1. Place the trampoline/enclosure on a level surface
before use.
2. Adequate overhead clearance is essential. A
minimum of 7.3 m (24 ft.) from ground level is
1. Make sure you understand the information in
the box at the top of this page before you
begin assembling the trampoline.
Lay Top Tube (1,4) and Corner Frame Tube (3) on
the ground as shown.
Insert Enclosure Socket (8) into each end of Corner
Frame Tube (3). Then insert Top Tube (1, with six
square hole) into Enclosure Socket (8) and insert
Top Tube (4, with ve square hole) into the other
Enclosure Socket (8).
Insert a Leg (6) into the Enclosure Socket (8) and
insert a second leg (6) into the other Enclosure
Socket (8). Insert a center (7) into the leg, slide a
second leg (6) onto the base. Tighten Self-tapping
Screws (17) into the small holes in two legs (6).
You have now assembled one leg section. Repeat
this step to assemble three more leg sections.
recommended. Provide clearance for wires,
tree limbs, and other possible hazards.
Lateral clearance is also essential. Place the
trampoline/enclosure away from walls, structures,
fences, and other play areas. Maintain a clear
space on all sides of the trampoline/enclosure.
3. Use the trampoline/enclosure in a well-lighted
area. Arti cial illumination may be required for
indoor or shady areas.
4. Secure the trampoline/enclosure against
unauthorized and unsupervised use.
5. Remove any obstructions from beneath the
trampoline/enclosure.
6. The owner and supervisors of the trampoline
are responsible to make all users aware of
practices speci ed in this manual.
7. The trampoline/enclosure is only to be used
as an enclosure for a round trampoline.
1
7
17
6
3
4
15
6
1
8