Moen GGA60 Série Directives D'installation

Installation Instructions GGA60 Series and GGA61 Series
Instrucciones de instalación para series GGA60 y GGA61
HELPFUL TOOLS
HERRAMIENTAS ÚTILES
OUTILS UTILES
GGA61 - DISPOSAL FLANGE
Make sure disposal is
1
installed properly to sink
and clamp is secured.
Clean inside of metal
2
collar. (supplied with
garbage disposal)
Lubricate flange gasket
3
with water and push
flange slowly into the
metal collar. Press firmly
until in place.
Lubricate gasket on
4
strainer with water
and push slowly into
the flange.
Directives d'installation des séries GGA60 et GGA61
SINK
METAL
COLLAR
DISPOSAL
FLANGE
GASKET
SINK
METAL
COLLAR
STRAINER
GASKET
FLANGE
SINK
GGA60 - DRAIN ASSEMBLY
Apply a small amount of
1
neutral cure silicone
caulk /adhesive under
the rim of strainer flange.
Place into sink.
2
Lubricate flange gasket
3
with water, place into
lip of drain body and
position drain body on
the sink bottom.
Line up ribs in drain body
4
and strainer flange
then screw in ferrule.
Caution: Hand tighten
then 1/4" turn with small
screw driver. Do not over
tighten. Remove excess
caulk / adhesive.
Push strainer into ferrule
5
in drain body.
Make sure washer is in
6
position. Slide nut on
1-1/2" drain tubing and
hand tighten the drain
body nut. Test for leaks.
INS10878 - 4/19
RIM
STRAINER
FLANGE
SINK
FLANGE
GASKET
DRAIN BODY
FERRULE
SINK
STRAINER
SINK
WASHER
DRAIN BODY
NUT
DRAIN TUBING
(NOT SUPPLIED)