Imetec E4501 Mode D'emploi page 21

Problem
The plate remains
There is no power supply.
cold or does not
heat up.
The plate
temperature LED Normal procedure.
½Å»É ÅÄ ·Äº Å
The steam selector (5) is
set to Ø .
Only a little steam
There is not enough water
or none at all is
in the reservoir.
dispensed.
The anti-drip system is
activated (if present).
Possible residue in the
steam chamber/plate.
Chemical additives,
scented liquids or
The impurities that
descaling agents are being
come out from the
used.
steam holes stain
Pure distilled water or
the garments.
softened water is being
used.
Starch is being used.
The plate temperature
is too cold due to the
Super-steam button being
pressed too often (4).
Water escapes
from the plate.
The temperature
adjustment knob (2) is set
to minimum Ø (Fig D).
Possible cause
Verify whether the plug is inserted
correctly or try inserting it in another
socket.
Verify whether the temperature
adjustment knob (2) is set to the
minimum temperature Ø (Fig D).
This indicates the heating phase of the
¿ÈÅÄ ¾» 
temperature is reached.
Set the steam selector (5) to the
º»É¿È»º »Âº
Fill the reservoir.
Wait for the plate to reach the correct
temperature once again.
Carry out the Self Clean procedure
(see paragraph Seal Clean/Calc-Clean
System).
These damage the product: do not add
additives to the water in the reservoir.
Mix tap water (50%) with distilled and
or demineralised (50%) water.
Always spray the starch on the reverse
side of the fabric.
Allow slightly longer intervals between
the jets of steam.
Turn the temperature adjustment knob
(2) to a higher setting.
GB
Solution
½Å»É Å ÅĹ» ʾ» É»Ê
¿½
19