Spray Function; After Ironing - Imetec E4501 Mode D'emploi

GB
Steam can only be used at the highest temperatures, as indicated by the symbol on the
temperature adjustment knob (2) [Fig. D].
If the selected temperature is too low, water droplets may drip from the plate.
Warnings: the plate temperature LED (1) goes on intermittently while ironing, thereby
indicating that the selected temperature is maintained.
         
Press the super-steam button (4) to generate a strong shot of steam that penetrates the
fabric and eliminates the most difficult creases.
Wait a few seconds between each pressing action of the iron [Fig. E].
Press the super-steam button (4) intermittently to iron in an upright direction (curtains, hung
clothes, etc.) [Fig. F].
Warnings: The super-steam function can only be used at high temperatures.
Stop the steam when the plate temperature LED (1) lights up and start ironing when this
goes off.

SPRAY FUNCTION

Verify that there is water in the reservoir (11).
Press the spray button (3): slowly for dense spray or fast for mist [Fig. G].
Warnings: first dampen the fabric lightly using the spray function (3) or alternatively, lay a
damp cloth between the fabric and the iron.
Do not use the spray on silk or synthetics.
        
The anti-drip system allows the more delicate garments to be ironed at low temperatures.
If the plate cools down enough for no steam to be produced, the hot water droplets can drop
on the fabric, leaving stains.
In this case, the Anti-drip System intervenes automatically by blocking the steam function,
thereby allowing the more delicate garments to be ironed without the risk of ruining or
staining them.

AFTER IRONING

EMPTYING THE IRON
Disconnect the plug (12) from the socket.
Empty the reservoir (11) by turning the iron upside down and shaking it lightly.
Let the iron cool down completely.
Always set the iron upright.
17