BS Charger BA 10 Instructions De Montage page 5

• If the Battery is still in the vehicle, determine if the vehicle is positively (+) or negatively (-) earthed.
-
If Negatively Earthed (Most Common) – FIRST Connect the Red (+) battery charger lead to the positive (+) Battery post and
then connect the Black (-) battery charger lead to the vehicle's chassis and away from the fuel line.
-
If Positively Earthed – FIRST Connect the Black (-) battery charger lead to the Negative (-) battery post and then connect the
Red (+) battery charger lead to the Vehicle's chassis and far away from the fuel line.
Black
STEP 3 - Connect the battery charger to Mains Power (230Vac)
• Connect the battery charger to a 230VAC Mains Powered socket.
•
Turn on the 230VAC Mains Power.
•
The Charger will automatically start when AC power is connected and switched on.
(Note: If the Fault Indicator LED illuminates Red, please check your connections as it's likely that the Positive and Negative Leads
are reversed. Refer to Trouble Shooting Page for further information)
STEP 4 - Disconnecting the Battery charger from Battery
•
If the Battery is out of the vehicle.
-
Switch OFF and Remove the AC Power Socket from the outlet.
-
Remove the Black lead and then the Red lead.
-
Check electrolyte levels if possible.
(As they may need topping up with distilled water after charging)
If the Battery is in the vehicle.
-
Switch OFF and Remove the AC Power Socket from the outlet.
-
Remove the lead from the vehicle chassis.
-
Remove the lead from the battery.
-
Check electrolyte levels if possible.
(As they may need topping up with distilled water after charging)
| www.bs-battery.com
Red
Connection in vehicle
(negativel y earthed)
Connection in vehicle
(positivel y earthed)
BLACK
Red
5