Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting

Symptom
The flash does not work • Make sure that this unit is properly inserted
28-GB
Remedy
into the advanced accessory shoe, or the
connection cord is properly attached to this
unit when using the connection cord.
• Make sure that the POWER switch on this unit
is "ON".
• If the READY lamp is not lit (orange), check
the READY lamp again in this instruction
manual.
• The flash does not fire if the subject is bright
with the digital still camera in the AUTO
mode (no display). To forcibly fire the flash
when the subject is bright, press the flash
button on the digital still camera.
• Make sure that the "Hot Shoe" on the digital
still camera is not set to [OFF].
• Depending upon the mode position on the
digital still camera, flash is not fired.
For details, refer to the operating instructions
of your digital still camera again.

Publicité

Table des Matières
loading

Table des Matières