Ii.4.4. Installation Inside A Buried Container On The Internal Vault; Ii.5. Installation Of The Sensor On Or In A Metal Container; Ii.5.1. Outdoor Installation On The Top Of A Metal Container - GST Smart bin Manuel

Figure 23 : Internal metal structure specific to the waste container
II.4.4.
vault
In this case the sensor is fixed on a fixing rod (a curved "L" rod) and the whole is fixed on the
vault of the container.
II.5. Installation of the sensor on or in a metal container
II.5.1.
When the sensor is installed on the ceiling of the metal container, therefore outside the
container, there are
- 2 holes with a diameter of
opposite the holes (nos. 2 and 4). This releases the position of the antenna
materialized by
- 1 hole with the diameter
- 1 hole for temperature and humidity probes (nos. 6).
As TWO of the FOUR closing screws of the housing (nos. 2 and 4) also serve to hold it to the
mounting bracket, it is important to leave on the housing the 2 closing screws (M4X20 or M4X25
numbered 1 and 3) , supplied with the sensor, and to attach the TWO fixing screws of length 60
mm (M4X60, numbered 2 and 4) only through the mounting bracket.
Thus, before the final fixing of the housing, it will be closed by the 2 screws nos. 1 and 3, and the
2 screws nos. 2 and 4 to be placed will be only from the outside in order to be able to perform
the closing and fixing functions of the sensor, as on the
Manuel utilisateur - User manual - Simplified version release 1.0
Installation inside a buried container on the internal
Outdoor installation on the top of a metal container
4 holes to be made there:
X mm on
the red dot on the
X mm
the support in which INSERTS are inserted
Picture 25
for the filling level probe (nos. 5)
Picture 27.
26