Ii.4.2. Indoor Installation On The Top Of The Plastic Container - GST Smart bin Manuel

Picture 20: 2 holes for external fixing (2 and 4) and 2 holes for measurements (5 and 6)
II.4.2.
When the sensor is installed under the ceiling of the plastic container, therefore inside the
container, then there are
- 2 holes with a diameter of
opposite the holes (nos. 2 and 4). This releases the position of the antenna
materialized
As TWO of the FOUR closing screws of the housing (nos. 2 and 4) also serve to hold it to the
mounting bracket, it is important to leave on the housing the 2 closing screws (M4X20 or M4X25
numbered 1 and 3), supplied with the sensor, and to attach the TWO fixing screws of length 60
mm (M4X60, numbered 2 and 4) only through the mounting bracket.
Thus, before the final fixing of the housing, it will be closed by the 2 screws nos. 1 and 3, and the
2 screws nos. 2 and 4 to be placed will be only from the outside in order to be able to perform
the closing and fixing functions of the sensor, as on the
Manuel utilisateur - User manual - Simplified version release 1.0
Indoor installation on the top of the plastic container
2 holes to be made there:
X mm on
by the red dot on the
the support in which INSERTS are inserted
Picture Figure 7.
Picture 27.
24