GST Smart bin Manuel page 20

Picture 15: Photo of the sensor base with inserts for closing / fixing
Pole
Positif
(+)
Pole
Négatif
(-)
This operation is the only one covered by the sensor warranty. The operator must therefore not
manipulate the electronic card, including unscrewing the 3 screws securing it to the base of the
housing, visible at Picture 21.
Once the battery2, with a sufficient residual energy level, is inserted, the first cycle occurs within
one minute. Finally, we remind you that when the sensor is switched on for the first time, a self-
calibration is performed as described in paragraph I.6.2.
20
Manuel utilisateur - User manual - Simplified version release 1.0