EN – Installation manual
Permissible use
The brackets must only be used for installing
radiators.
Any other use is contrary to its intended purpo-
se and therefore not permissible.
Safety instructions
►
Read these instructions thoroughly prior to
installation.
DANGER
Life-threatening situation!
Check the condition of the supply lines
►
(electricity, gas, water).
Do not drill into any lines.
►
WARNING
Personal injury and material damage!
Check substrate for load-bearing capaci-
►
ty. Take the filled weight of the radiator
(see manufacturer documentation) and
possible additional loads into account.
Check fasteners for applicability and tai-
►
lor them to the structural situation.
Take special requirements, e.g. for public
►
buildings (schools or the like), into
account.
Disposal
Packaging and any parts that are not nee-
►
ded should be recycled or disposed of pro-
perly. Observe local regulations.
Installation
(Fig. see p. 19–22)
Installing brackets
Check fastening material for damage.
►
Prepare tools.
►
Mark position for upper holes to be drilled:
►
–
Number of brackets, see attachment.
–
Radiator dimensions, see radiator in-
struction and installation manual.
–
Radiator strap reference dimension, see
Fig. 2.
►
Drill holes and insert wall anchors. Note the
material used for the wall.
►
Attach, align and tighten brackets.
Install the lower retaining screws. Ensure
►
that the wall anchor is flush with the front
edge of the bracket.
Attach sound-absorbing clips to all brackets.
►
Attach lift restraints to the outer brackets.
►
Set distance of heater to the wall
Undo hexagonal socket head screw.
►
Set spacer.
►
Tighten hexagonal socket head screw.
►
Installing spacers (one-row installation only)
Depending on the installation situation,
►
use spacer extensions as necessary (see ma-
nufacturer documentation).
Installing and securing the radiator
►
Place the radiator with the straps into the
brackets and align laterally.
►
Clamp the lift restraints over the radiator
straps.
3