Flex PE 150 18.0-EC Notice D'instruction D'origine page 21

PE 150 18.0-EC
Attaching tool holder
Remove the battery.

Press and hold down the spindle lock (1.)

Screw tool holder (Velcro plate) in

clockwise direction onto spindle and
tighten by hand (2.).
Secure tool on tool holder.

Insert the battery.

Switch on the polisher (without

engaging it) and run the polisher for
approx. 30 seconds. Check for
imbalances and vibrations.
Switch off the polisher.

Changing tool holder
Remove the battery.

Press and hold down the spindle lock.

Unscrew tool holder in anti-clockwise

direction and remove it from the spindle
by turning.
Secure new tool holder (see above).

Insert the battery.

Attaching the tools
CAUTION!
Attach tools centrally on tool holder.
Imbalances may damage the power tool.
The work result may be impaired.
NOTE
Use original FLEX accessories on this
model. Not using original FLEX accessories
may lead to a poor polishing result,
increased vibrations and also greater wear
or even damage to the power tool.
Information concerning foam wear
NOTE
In general, foam wear is much higher in
connection with free-wheeling eccentric
polishing that with rotational polishing or force-
driven eccentric polishing.
Due to the drive, this wear does not take
place on the outside of the foam but at the
foam core instead. The harder/longer the
cell structure is subjected to strain and
damaged as a result, the faster the build-up
of heat. Subsequent damage is inevitable.
Wear of this kind cannot be seen on the
foam externally. The only reliable action is
replacement and disposal in good time to
prevent thermal damage to the power tool.
Switching on and off
Brief operation without engaged switch
rocker
Press and hold down the switch.

To switch off, release the switch.

21