Installation Of Front And Side Panels (Where Included); Control Panel And Functions; Setting The Water Temperature; Water Temperature - Jacuzzi Skylounge Manuel D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
nance, the methods and warnings governing the use of rela-
tive chemical products.
After a few hours, turn off the omnipolar switch.
Open the drain valveand completely empty the hot tub.
If included, re-install the front and side panels.
CAUTION
Do not use the hot tub the first time you start it as there
is a high concentration of chlorine in the water during
this phase. Immediately empty the bath.
Contact the local authorities for the standards govern-
ing the discharge of chemically treated water.
Close the drain valve(s) and fill the hot tub again with fresh
water as previously explained.
Turn the omnipolar switch back on and check that the hot
tub works correctly.
Proceed with the chosen water treatment.
WARNING: read and follow all the instructions related
to the use and storage of chemical products, adhering
strictly to the manufacturer's instructions on the pack-
aging.
WARNING! Do not use trichlorine tablets! This may
damage the hot tub components and cause burning or
irritation to the skin and mucous membranes. Any use
of these chemicals voids the manufacturer's warranty.
Check and as necessary modify the water filtering cycles
based on how you intend to use the hot tub.
alternatively
B
pump
A
spotlight
filtering LED
heater LED
Temperature adjustment LED
viewing and adjusting temperature,
parameters, functions
Installation of front and side panels
(where included)
Refer to the corresponding drawings. (

Control panel and functions

(
3/6) All hot tub functions are managed via the control panels
on the tub, as are the respective settings/programming (display B
only).
NOTE Up/Down button
increase; once the key is released, the direction will reverse (when
pressing the key, the display value will decrease) and so on.

Setting the water temperature

The water is heated
with an electrical heater. Do not set an exces-
sively high water temperature, i.e. over the limit of 40 °C. The recom-
mended temperature is 35-36 °C.
M
ODELS WITH A HEATER
tive (see relevant chapter) and, by switching on the pump, the heat-
er turns off (the led relative to the symbol
will be turned on again, if necessary, 10 seconds after the pump
itself is turned off.
W
ATER TEMPERATURE
To check or modify the water temperature, do the following:
Press the "Up/Down"
show the current saved temperature.
Press the key "Up/Down"
30
2).
(display
B): hold down the key to
:
if the electric consumption limit is ac-
flashes), the heater
("
")
SET POINT
key (display B): the display will
again to change the displayed
6

Publicité

Table des Matières
loading

Table des Matières