Sanitas SBM 37 Mode D'emploi page 25

• You can take the measurement while sitting or lying down.
Always make sure that the cuff is at heart level.
• To carry out a blood pressure measurement, make sure you are
sitting comfortably with your arms and back leaning on some-
thing. Do not cross your legs. Place your feet flat on the ground.
• To avoid falsifying the measurement, it is important to remain
still during the measurement and not to speak.
Performing the blood pressure measurement
As described above, attach the cuff and adopt the posture
in which you want to perform the measurement.
• Press the START/STOP button
to start the blood pressure monitor.
All display elements are briefly displayed.
The blood pressure monitor will begin the
measurement automatically after 3 seconds.
• You can cancel the measurement at any time by pres-
sing the START/STOP button
As soon as a pulse is found, the pulse symbol
displayed.
• The systolic pressure, diastolic pressure
and pulse rate measurements are displa-
yed.
• appears if the measurement could not
be performed properly (see chapter 9 "Er-
ror messages/troubleshooting"). Repeat the
measurement.
.
will be
25
• Now select the desired user memory by pressing the
M1 or M2 memory buttons. If you do not select a user
memory, the measurement is stored in the most recently
used user memory. The relevant
on the display.
• Press the START/STOP button
pressure monitor. The measurement is then stored in the
selected user memory.
• If the device is not switched off manually, it will switch
off automatically after 3 minutes.
If Bluetooth data transfer has been activated, data is
®
by transferred after having confirmed the user memory by
pressing the pressing the START/STOP button
• The Bluetooth symbol on the display flashes and the
®
blue LED lights up. The blood pressure monitor now at-
tempts to connect to the app for approx. 30 seconds.
• The Bluetooth symbol stops flashing as soon as a con-
®
nection is established. All measurement data is automa-
tically transferred to the app. Once the data has been
successfully transferred, the device switches off. If the
data transfer was unsuccessful, the blue LED goes out
and " " appears on the display.
• If a connection to the app cannot be established after
30 seconds, the Bluetooth
blood pressure monitor switches off automatically after
3 minutes.
or symbol appears
to switch off the blood
.
symbol goes out and the
®