Explanation Of The Included Products - Luda Elektronik trailerCam Guide D'utilisation

4. Explanation of the included products

Lens
IR-LED
Mountingfoot
Adjustment screws
The camera can be angled in different positions depending on where it is being mounted. Loosen and/
or move the adjustment screws until desired angle is achieved. The camera can be mounted in the front
or in the back of the trailer depending on the model of the trailer and what power supply is preferred.
The entire installation process can be found in chapter 7.
Channel selector screw - change of frequency
If you experience any reception problems like noise or interference in the picture, changing the channel
of your camera can eliminate the problem. The transmitting channel of the camera is selected by
inserting the larger screw into the upper hole on the back of the camera. Use a coin or large screwdriver
to fasten the screw. Notice! Make sure the screw goes all the way in and tighten securely to lock
the channel.
Notice! If you change the camera's transmitting channel you must also change the LCD-monitor's
receiving channel by simply pressing the channel selector.
Wireless video camera
To select channel 2 (2432 MHz)
place the screw in the upper
hole, closest to the antenna.
To select channel 4 (2468 MHz),
remove the screw from the
camera.
- 28 -
Antenna
Adjustment screws
Channel selector
screw (backside)