Bresser National Geographic 9039100 Mode D'emploi page 10

Place a permanent slide culture directly under the microscope lens on the plate (7).
The specimen to be examined must be directly over the lighting.
Look through the eyepiece (1 and 2) and carefully turn the focus wheel (8) until you
can see a sharp picture.
Now you can progress to a higher magnification. Slowly pull the Barlow lens (No. 2, 3)
out of the monocular barrel (No. 2, 4). When the Barlow lens is nearly entirely pulled
out, the magnification is raised to 2X.
For even higher magnification, you can put the 16X eyepiece (2) into the objective
revolver (6) and rotate the objective revolver to a higher magnification (10X or 40X).
TIP:
i
Depending on the preparation, higher magnifications do not
always lead to better pictures.
When changing the magnification of your microscope by changing or adjusting the
eyepiece, objective lens or Barlow lens, you must readjust the focus wheel (8) to
sharpen the image.
NOTE:
Please be very careful when doing this. If you move the mechanical
plate upward too fast, the objective lens and the slide can touch and
become damaged.
6� Experiments
Use the following web link to find interesting experiments you can try out.
http://www.bresser.de/downloads
How do I install the MicrOcular?
Note:
The MicrOcular only works without the included Barlow lens! The magnification setting
10
is changed when the MicrOcular is used, and it must be readjusted with the focus knob.
Fig. 5
f
D
First, remove the Barlow lens (Fig. 5, 3) with the current eyepiece from the eyepiece
support (Fig. 5, 5) and place the MicrOcular (Fig. 6, 4) in the eyepiece (Fig. 6, 5).
How do I install the software?
1. Y ou can download the setup file for installation here:
www.bresser.de/download/CamLabLite
2. Start the installation with a double click on the .exe file and follow the instructions
of the installation manager.
3. It is not necessary to install a special driver. The camera is automatically recognized
by your Windows operating system.
Using the MicrOcular
Preparation
1. Slide a specimen under your microscope and focus on it.
2. Remove the eyepiece and Barlow lens from the eyepiece support and the dust cap
from your MikrOkular and then install the MikrOkular into the eyepiece support in-
stead of the Barlow lens.
3. Start your PC if you haven't yet and connect your MikrOkular to the USB port of your
computer.
4. Start the „CamLabLite" software and activate the camera by clicking on „USB Video
Device.
5. Click on „Snapshot" to take a picture or on „Capture" to record a video.
6. Click on the floppy disk icon to save the image or capture.
Fig. 6
E
F