Functions; Power Supply - babymoov Babyphone High Care Notice D'utilisation

Babyphone High Care
EN
Thank you for choosing our Baby monitor High Care. We recommend you read these instructions
carefully in order to use your Baby monitor to best advantage and ensure it continues to operate as long
as possible. If you should find a fault, however, or if you have any problem, please contact our company.
IMPORTANT: This baby monitor uses low emission power, in order to protect baby's health. The receiver
and the transmitter don't communicate continuously, in order to limit the emission of radiations in the
room. When baby cries, the system is activated immediately to alert parents; when the baby doesn't
cry, the transmitter and the receiver communicate only each 20 seconds to check the good communication
and update information such as the room's temperature.
• Range 1,000 m in an open space.
• 2 channels + 68 digital codes (total of 136 sub-
channels) to offer a high degree of protection
against all kinds of interference.
• Receiver fitted with a lithium battery that recharges
on its base.
• Alarms : audible, visual and vibrations on the receiver.
• Volume control on the receiver and on the transmitter.
• Gentle night light on the transmitter.
• Microphone sensitivity can be adjusted digitally
on the transmitter.
- The Baby monitor High Care should not be seen as a medical device. In addition to using Baby monitor
High Care, it is strongly recommended that an adult checks on your baby directly, on a regular basis.
Premature babies or children considered to be at risk should be monitored by your paediatrician or a health
professional.
- Never go away from your baby outside the house, even a short moment.
- Non-rechargeable batteries are not to be recharged ;
- Rechargeable batteries are to be removed from the device before being charged ;
- Different types of batteries : new and used batteries, or rechargeable and not rechargeable batteries, are
not to be mixed ;
- Rechargeable batteries are only to be charged under adult supervision ;
- Batteries are to be inserted with the correct polarity (+/-) ;
- Exhausted batteries are to be removed from the device ;
- The supply terminals are not to be short-circuited.
- Always use the supplied battery for the receiver : if the battery is damaged it must be replaced by the
manufacturer, the after-sales service or people with similar qualifications, in order to avoid any risk.
A / Transmitter
1. Operation using batteries (not supplied)
Press down the lock button and slide open the
battery door. Insert three pieces AAA size (UM-4)
alkaline batteries into the compartment. Observe
correct polarities indication (+/-).
INSTRUCTION MANUAL

FUNCTIONS

WARNINGS

POWER SUPPLY

BABYPHONE HIGH CARE • Instruction Manual
• Temperature of baby's room indicated on both
the receiver and transmitter and audible and visual
"Temperature too high/low" alarm on the receiver
(parents can adjust the temperature range).
• Distance alarm which goes on when the child
moves away more than 25 metres from his parents.
• Audible and visual alarm on the receiver when
the transmitter is out of range.
• Battery condition indicated on both the transmitter
and receiver, and alarm when batteries need
changing or recharging.
• Selectable Hi/Lo emission power on transmitter to
prolong battery life and minimize radiation level.
1
2
13