Allen-Bradley 931S-B1C6D-DC Notice D'utilisation page 3

1. General instructions
WARNING WARNING WARNING WARNING
• Disconnect power prior to installation
• Installation only by Qualified personnel
• Follow all applicable local and national electrical codes
• Due to potential hazardous voltages in close proximity, use a non-
conductive tool and proper PPE when adjusting the potentiometers
on the front panel.
For applications with high isolation voltages, take measures to prevent
accidental contact and make sure that there is sufficient distance or
insulation between adjacent devices!
Appropriate safety measures against electrostatic discharge
(ESD) should be taken during assembly and adjustment work on
the 931S-B1C6D-DC
2. Application
The 3 Way Bridge Converters 931S-B1C6D-DC are used for galvanic
isolation and conversion of voltage signals. Input and output signals can be
calibrated/switched via DIP switches. It is not necessary to adjust the
pre-settable measurement ranges. The output signal is linear to the
measured voltage.
The supply voltage to the bridge can be set between 4.8 V...10.2 V;
in addition, the offset can also be set.
1