Basics; Making Calls - Sony CALLER ID SPP-ID400 Mode D'emploi

Basics

Making calls

VOL
switch
(CHANNEL)
(REDIAL/PAUSE)
(*TONE)
Additional tasks
To
Improve reception
Adjust the handset volume
Switch to tone dialing temporarily Press (*TONE) after you're connected.
If the battery becomes weak during a call
The handset will beep every three seconds and i and "BATTERY
LOW" appears on the display. The call will be disconnected in one
minute. Finish your call and charge the battery pack.
If this occurs, you cannot use the handset without charging it for
more than one minute.
1
Pick up the handset from the
base unit.
2
Press (TALK) and wait until
"TALK" appears on the display.
You then hear a dial tone. If you
hear beeps, move closer to the
base unit.
3
Dial the phone number.
4
When you're done talking, press
(OFF) or replace the handset on
the base unit.
The display goes off.
Do this
Press (CHANNEL).
Slide VOL.
The line will remain in tone dialing until
disconnected.
continued
EN
13
Basics