Service/Maintenance Guide - Bronze/Sopra 100; How Often; Service/Maintenance Guide - Silver/Sopra 160 / Gold/Sopra 260 Gold Rrc/Sopra 260 Rrc - Nilfisk Sopra 100 Mode D'emploi

10.1

Service/maintenance guide - Bronze/Sopra 100

NB! Never vacuum without a fi lter and dust bag installed in the modell Bronze/Sopra 100
Product

How often?

Dust bag
Should be replaced
before it becomes
completely full,
depending on use but
normally 2-4 times a
year.
Filter in
Should be checked
bottom when changing the
bag.
10.2 Service/maintenance guide - Silver/Sopra 160, Gold/Sopra 260,
Gold RRC/Sopra 260 RRC
NB! Never vacuum without a fi lter installed.
Product How often?
Should be emptied
Dust
before the container is
container
3/4 full, depending on
use but normally 2-4
times a year.
Should be replaced
Dust bag
before it becomes
completely full,
depending on use but
normally 2-4 times a
year.
Filter Should be shaken
when the container is
emptied.
NB: Only use dry
cleaning methods
Why? How?
Poor suction and
Grasp the edge of the lid and open it by pulling upwards.
danger of creating
Remove the old dust bag by turning the cardboard
a blockage in the
stiffener to the right or left so that the elevation on the
pipe system.
nozzle penetrates the opening in the cardboard. Now slide
the bag off the inlet. Push the opening in the cardboard
over the elevation on the inlet and pull on the new bag.
Twist the cardboard to lock the bag in place. NB! The
opening in the card must be adjusted and pushed past the
elevation on the inlet before the cardboard can be locked
into place with a twisting action.
NB! Never vacuum without a dust bag installed.
Poor suction can
Remove the dust bag as described above. Remove the
result. Dust can
fi lter from the bottom. The fi lter can be cleaned by shaking
fi nd its way into
it or washing it in water. NB! The fi lter must be completely
the motor.
dry before being reinstalled. Replace the cleaned fi lter
in the machine. Press the outer edge of the fi lter down
against the sides of the container so that the fi lter bulges
up slightly. Refi t the dust bag and replace the lid. Check
that the lid is sitting fi rmly in place.
NB! Never vacuum without a fi lter installed.
Why? How?
Then loosen the handles on the container (pull out from
Danger of
the machine) to free the container from the machine. Lift
blockage in the
out the fi lter and dust bag - see additional information
pipe system.
below. Empty the dust into a plastic bag and put in
dustbin. Any remaining dust or fl uff can be removed
manually.
Poor suction Then loosen the handles on the container (pull out from
and danger the machine) to free the container from the machine.
of creating a Lift off the container. Lift out the fi lter. Then remove the
blockage in the dust bag by pulling the bag's cardboard stiffener off the
pipe system. nozzle.
Replace in reverse order.
To maintain good
Loosen the handles on the container by pulling the
suction power.
handles in an outward direction from the machine.
Remove the container from the machine.
Do not remove the fi lter from the container. Instead, give
the fi lter a light shaking inside the container to loosen
dust from the fi lter and allow it to fall into the container.
Lift out the bag fi lter. If a dust bag is being used - remove
it. Then empty the dust from the container in a suitable
place.
www.nilfi sk-advance.com
43