Noise And Vibration Declaration Statement - Husqvarna Soff-Cut 150 Manuel D'utilisation

Max. cut depth, in/mm
Cutting distance from wall, in/mm
Blade rotation
Blade shaft speed, rpm
Blade depth control
4
Average cutting rate
Soft aggregates, ft/min or m/min
Medium aggregates, ft/min or m/min
Hard aggregates, ft/min or m/min
Recommended dust extractors
3
Min. Air flow m /h or CFM
Min. Vaccum, kPa/psi/
Min. Water lift, in/m
Dust extractor attachment, in/mm
Noise and vibration declaration
statement
These declared values were obtained by laboratory type
testing in accordance with the stated directive or
standards and are suitable for comparison with the
declared values of other products tested in accordance
with the same directive or standards. These declared
values are not suitable for use in risk assessments and
values measured in individual work places may be
higher. The actual exposure values and risk of harm
experienced by an individual user are unique and
depend upon the way the user works, in what material
the product is used, as well as upon the exposure time
and the physical condition of the user, and the condition
of the product.
4
Estimate only. Speed will vary with job conditions and concrete mixes.
5
Technical data for dust extractors are not conclusively describing actual performance over time between dif-
ferent dust extractors. For Husqvarna products OSHA objective data are available at www.husqvarnacp.com/
us/.
714 - 004 - 06.07.2021
Soff-Cut 150
38.1/1.5
3/76
Counterclockwise, upcutting
4500
Manual
12/3.7
8/2.4
4/1.2
5
400 or 236
22/3.6
90/ 2.3
2/ 60
Soff-Cut 150D
12.7/0.5
4 ½/114
Counterclockwise, upcutting
4500
Manual
29