Assembly:
NOTE: Each steam mop is 100% tested in the factory to ensure product performance and
safety. When assembling your new steam mop for the first time you may notice water residue
inside of the unit.
! WARNING: Before attempting any of the following operations, make sure that the appliance
is switched off and unplugged and that the appliance is cold and contains little or no water.
Attaching the handle:
Slid the handle bar with the handle into the main body until it clicks into place
The handle can be removed from the steam mop body for easy storage by pressing
the Handle tube button
Attaching the steam head:
Slide the bottom end of the main body into
the steam head until the steam head spindle
clicks into place
The steam head can be removed from
the main body by pressing the salient point
on the steam head spindle
Attaching a cleaning pad:
As barb design at the bottom of the steam head, only
place a micro-fiber cleaning pad to the steam head, they can
bond hard
Place the front of your shoe onto the cleaning pad,
remove the tab and press down firmly
Attaching carpet gilder:
Press the micro-fiber cleaning pad E on the main body,
to the carpet gilder by vertical pressure, until it clicks into place
Place the front of your shoes onto the cleaning pad E removal tab
and press down firmly, the carpet gilder will remove
from the steam head.
25