Connecting To A Lan (Vpl-Px15 Only) - Sony VPL-PX15 Mode D'emploi

To connect 15k RGB/Component
equipment
Left side
MOUSE
PLUG IN POWER
CTRL S AUDIO INPUT A
Stereo
audio
connecting
cable (not
supplied)
to audio
output
15k RGB/Component
equipment
Notes
• Set the aspect ratio using ASPECT in the INPUT
SETTING menu according to the input signal.
For details, see page 30 (GB).
• When you connect the projector to 15k RGB/
component video equipment, select RGB,
component or VCR GBR with the INPUT-A setting
in the SET SETTING menu.
• Use the composite sync signal when you input the
external sync signal from 15k RGB/component
equipment.
AUDIO VIDEO S VIDEO
~AC IN
SMF-402 Signal Cable (not
supplied) HD D-sub 15-pin
(male) y 3 × phono jack
to RGB/
component
output
Connecting to a LAN (VPL-PX15
only)
This projector is networking compatible. Using a
wireless LAN PC card or a 10BASE-T/100BASE-TX
LAN cable, you can connect the projector to a
wireless or wired LAN. You can also install a PC
memory card.
This section describes how to connect to a LAN and
how to install a PC card.
Whenever you connect the projector to a LAN or use
a memory card, set INPUT-B FUNC. in the
INSTALL SETTING menu to ON.
For details, see page 33 (GB).
Installing a PC card
When you use a wireless LAN PC card or memory
card, insert the card into the INPUT B PC CARD
slot.
The eject button pops out
when the card is inserted.
Insert the card with the arrow mark
facing toward the slot.
To remove the PC card from the slot, press the eject
button.
Connecting the Projector
PC card
21
(GB)