Installation Of A Pvc Fitting With Weld-End Connections On A Pipe; Installation Of A Saddle On A Pipe - Burkert S022 Manuel Utilisateur

→
Immediately remove the unwanted adhesive with blotting paper.
→
Insert seal "C" into groove "D".
→
Put the previously glued assembly on the seal.
→
Screw nut "A" with the hand to make the assembly solid.
→
Before charging the pipe let the assembly dry for at least 15
hours.
6.2.7. installation of a PVc fitting with
weld-end connections on a pipe.
A
→
Take the glass off the surface "A" and the internal surface "B" of
the connection "C" of the fitting with emery cloth.
→
Wipe the surfaces"A" and "B" with blotting paper.
→
Scour the surfaces "A" and "B" then clean them with blotting
paper.
→
Let dry.
24
C
B
English
Type S022
Installation,commissioning
→
Eliminate any trace of humidity due to condensation.
→
Coat the surface "A" with glue.
→
Apply a thicker layer of glue on surface "B", strongly pressing the
brush in the direction of the axis.
→
Assemble the 2 glued workpieces to the stop, keeping them
aligned and without turning the workpieces.
→
Keep the workpieces together until the glue sets.
→
Immediately remove the unwanted adhesive with blotting paper.
→
Before charging the pipe let the assembly dry for at least 15
hours.
6.2.8.

installation of a saddle on a pipe

Seal
Seal
Screws
Nut
Pipe
26 mm