Fuse Replacement-Dc Charging Adapter; Troubleshooting Guide - Wagan Tech SOLAR e POWER CUBE 1500 PLUS Guide D'utilisation

Solar e Power™ Cube 1500 Plus by Wagan Tech
• Check wiring or cables that are attached to the solar panels. Wire or cables may
become loose from turbulent weather conditions.
• Store panels when not in use.
Fuse Replacement—DC Charging Adapter
The DC Charging Adapter comes equipped with one 15A quick blow fuse inside each plug end.
To replace a fuse, simply unscrew the head of the plug and remove the fuse. If blown, replace
with a 15 amp fuse of the same type and rating.

TROUBLESHOOTING GUIDE

Problem
No AC output, Green
LED is not lit, Voltmeter
reads below 10 volts
No AC output, no
displays lit
No AC output, 12 volt
outlets operate, USB
ports operate. Inverter
Switch is ON
12 volt DC outlets
switch on and off
Television interference
Static/noise interfer-
ence in audio system
Run time is less than
expected
Charging light is OFF
when AC Charging
Adapter is connected
23
Possible Cause
Battery voltage too low
Excessive AC load
Battery Disconnect Switch
is OFF
Inverter is not working
DC Outlet is overloaded
Picture breaking up (static)
Sound system has weak al-
ternating current shielding
Solar e Power Cube is not
fully charged
Product power consumption
is higher than expected
No AC power at wall
socket
www.wagan.com
®
Solution
Reduce AC load and charge the Solar
e Power Cube battery
Turn ON Switch
Call Wagan Tech Support
Reduce DC load.
Place the Solar e Power Cube as far
as possible from the TV, the antenna
and the coaxial cable
TV station may be out of range
Do not use Inverter with low quality
audio AC filtering system
Replace audio system with high qual-
ity noise filtering
Charge using the AC Charging
Adapter.
Check the power or "wattage" rating
and compare with the tables in Bat-
tery Operating Times section of this
manual
Ensure power is available at the wall
socket