Fuse Replacement-Dc Charging Adapter; Troubleshooting Guide - Wagan Tech SOLAR e POWER CUBE 1500 Guide D'utilisation

Solar e Power
The solar panels should be periodically cleaned during extended use and before storing. Check
your panels weekly or following a storm to make sure no damage has occurred.
• Check for dirt buildup or bird droppings.
• Using a soft brush, remove dust or droppings from the panels.
• Wipe surface area of solar glass and frame with a soft damp cloth. Use mild dish soap
if necessary.
• Dry the panels with a soft cloth. Solar panels are more efficient when they are clean.
• Check wiring or cables that are attached to the solar panels. Wire or cables may
become loose from turbulent weather conditions.
• Store panels when not in use.
Fuse Replacement—DC Charging Adapter
The DC Charging Adapter comes equipped with one 15A quick blow fuse inside each plug end.
To replace a fuse, simply unscrew the head of the plug and remove the fuse. If blown, replace
with a 15 amp fuse of the same type and rating.

TROUBLESHOOTING GUIDE

Problem
No AC output, Green
LED is not lit, Voltmeter
reads below 10 volts
No AC output, no
displays lit
No AC output, 12 volt
outlets operate, USB
ports operate. Inverter
Switch is ON
12 volt DC outlets
switch on and off
Television interference
Static/noise interfer-
ence in audio system
24
Cube 1500 by Wagan Tech®
™
PoSSible CauSe
Battery voltage too low
Excessive AC load
Battery Disconnect Switch
is OFF
Inverter is not working
DC Outlet is overloaded
Picture breaking up (static)
Sound system has weak al-
ternating current shielding
www.wagan.com
SoluTion
Reduce AC load and charge the Solar
e Power Cube battery
Turn ON Switch
Call Wagan Tech Support
Reduce DC load.
Place the Solar e Power Cube as far
as possible from the TV, the antenna
and the coaxial cable
TV station may be out of range
Do not use Inverter with low quality
audio AC filtering system
Replace audio system with high qual-
ity noise filtering