Control Panel - Wagan Tech SOLAR e POWER CUBE 1500 PLUS Guide D'utilisation

Solar e Power™ Cube 1500 Plus by Wagan Tech

CONTROL PANEL

The Control Panel contains a Digital LED Voltmeter for reading battery status, a Battery Status
Push-Button to turn on the meter, Inverter ON/OFF switch, two AC Outlets, two USB and two
12 volt Accessory Outlets. Two LEDs indicate the operating condition of the Inverter. The green
Power LED, when lit, indicates normal operation and that AC is present at the outlets. The red
Fault LED indicates the Inverter is shut down because of any of the following reasons: over volt-
age, under voltage, over temperature or overload. Refer to the Troubleshooting section to resolve
the problem. Two terminals allow additional solar panels to be connected to the internal Solar
Charge Controller. The Battery Disconnect Switch is located to the left of the control panel. A
Storage Hatch contains the DC and AC Charging Adapters.
Digital LED
Voltmeter
Voltmeter
Push-button
2 AC Outlets
(Inverter)
7
VOLTMETER
DISPLAY
1500W, 115V AC
12V DC Accessory Outlets
Control Panel
www.wagan.com
®
Inverter
Power Switch
INVERTER FAULT
POWER
2.1A USB 1.0A USB
SOLAR
TERMINALS
Red Inverter
Fault LED
Green Inverter
Power LED
USB Outlets
Solar Panel
Terminals
Positive (+)
Negative (−)