Connection To A Positive Grounded Vehicle; Vehicle Battery Boosting Using The Dc Charging Adapter; Power Expansion Options; Adding Batteries To The System - Wagan Tech SOLAR e POWER CUBE 1500 PLUS Guide D'utilisation

Connection To a Positive Grounded Vehicle

If the vehicle to be started has a positive grounded system (positive battery terminal connected to
the chassis), substitute the following steps to the instructions above:
10. Connect the positive (+) red clamp to the vehicle chassis or a solid, non-moving metal
vehicle component. DO NOT clamp directly to the positive battery terminal or a moving
part.
11. Connect the negative (−) black clamp to the vehicle battery's negative terminal.
VEHICLE BATTERY BOOSTING USING THE DC CHARGING
ADAPTER
CAUTION —Do not leave the DC Charging Adapter connected to the vehicle's lighter socket
when starting the vehicle. Remove the DC Charging Adapter before starting the vehicle. This will
prevent the vehicle's DC socket fuse from blowing.
In some cases when the vehicle battery has enough power to crank the engine, but not enough
to start the vehicle, the DC Charging Adapter can be used to provide enough charge to the
vehicle's battery to start. Make sure the Solar e Power Cube is fully charged. The following
procedure outlines this process:
1. Make sure the Inverter switch is OFF and all appliances have been disconnected from
the Accessory Outlets and USB ports.
2. Turn ON the Battery Disconnect Switch.
3. Plug one end of the DC Charging Adapter to your vehicle's cigarette lighter (accessory)
socket. You may need to switch the ignition key to the "Accessory" position to supply
power to the lighter socket. Be sure to turn off any lights or accessories such as radio or
A/C fan that may be operating from the vehicle's battery.
4. Plug the other end into either of the two DC Outlets on the Solar e Power Cube control
panel.
5. Wait 15 minutes while the Solar e Power Cube trickle charges you vehicle's battery.
6. Remove the DC Charging Adapter from the vehicle's cigarette lighter socket before at-
tempting to start the engine.
7. If your vehicle engine cranks but does not start, investigate for other problems.
8. Store the DC Charging Adapter in the Storage Hatch.
9. If the engine does not crank, follow the jump start procedures in the previous section.
10. Charge the Solar e Power Cube as soon as possible.

POWER ExPANSION OPTIONS

Adding Batteries to the System

For extended operating time, additional batteries may be added in parallel using the Battery
Terminals located above the wheels. Connect 12V AGM batteries into the system for long-term
Wagan Tech and wagan.com are trademarks used by Wagan Corporation
User's Manual—Read before using this equipment
© 2013 Wagan Corporation. All Rights Reserved
20