12V Dc Accessory Outlets - Wagan Tech SOLAR e POWER CUBE 1500 PLUS Guide D'utilisation

• Do not use the following with modified sine wave inverters:
• Small battery-operated appliances like flashlights, razors and night lights that
can be plugged directly into an AC receptacle to recharge.
• Some chargers for battery packs used in power hand tools. These affected
chargers display a warning label stating that dangerous voltages are present
at the battery terminals.
To use the AC Power Inverter:
1. Turn ON the Battery Disconnect Switch
2. Connect the AC appliance or appliances to either AC Outlet.
3. Turn the Power Inverter ON by positioning the switch to the "•" ON position.
4. When the Inverter Power Indicator LED is green, the Inverter is operating.
5. Turn on one AC appliance and observe the Power Indicator and FAULT LEDs.
• If the LED remains green, proceed to turn on the second appliance.
• If the Power Indicator LED continues to remain green, then both appliances are
operating properly.
• If the red FAULT LED light is lit, then remove all loads and restart the inverter
• If the Power indicator LED is not lit, then reduce the AC load. If the Inverter is
still not operating, refer to the Troubleshooting table at the end of this User's
Manual.
6. After appliance use, turn OFF the Inverter switch
7. Remove AC appliance plug(s) from the AC Outlets on the Solar e Power Cube
8. Recharge the Solar e Power Cube as soon as convenient.
Note: The external cooling fan operates whenever the Inverter is on. The cooling fan helps
maintain Solar e Power Cube internal temperature when products with high power requirements
are in use.

12V DC Accessory Outlets

DC Accessory Outlets can power a DC load up to 15 amps each. Overloading a port will result
in tripping a self-resetting circuit breaker. Removing the overload automatically restores power to
the DC Accessory Outlet once the circuit breaker has cooled.
CAUTION—Do not insert an automotive cigarette lighter into the Outlet. There is no pop-out
feature and excessive heat may damage the Outlet.
To use an Accessory Outlet:
1. Open the dust cover over the DC Accessory Outlet.
2. Insert the 12V DC accessory plug into the DC Outlet.
3. Turn ON the Battery Disconnect Switch
4. Operate the appliance as usual.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation
User's Manual—Read before using this equipment
© 2013 Wagan Corporation. All Rights Reserved
16