Controls Layout; Setting Up The Appliance; Power Supply - babymoov Easy Care A014015 Notice D'utilisation

Baby unit
1. ON/OFF and pairing button
2-3. Microphone sensitivity down adjustment button
4. VOX night light
5. Night light
6. Power On / Battery low icon
7. Transmit icon
8. Night Light VOX icon
9. Microphone always ON icon
10. Micro-USB port and power socket
Place the camera on a flat surface between 1 m and 2,50 m from the baby's
head. Point the camera lens and microphone towards the baby.
BABY UNIT + PARENT UNIT
• Operation from batteries
3 X AAA 1,5 V (not included)
N.B. The range is longer when the transmitter is running on a power outlet.
Before the first use, charge the Lithium-Polymer battery for at least 3 hours. It is recommended to turn off
the device during the first charge.
The baby and parent unit are already paired with factory preset code when they are shipped from factory. However, we
recommend to perform pairing again in case interference is experienced.
BABY UNIT
1. OFF button.
PARENT UNIT
5. Repeat the same operations on the PARENT UNIT.
6. Turn off the receiver and the transmitter and then turn them on again.
Congratulations! Your camera is now connected!

CONTROLS LAYOUT

SETTING UP THE APPLIANCE

POWER SUPPLY

2. Keep pressing the volume
up button.
BABY MONITOR EASY CARE • Instruction manual
Parent unit
11. ON/OFF and pairing button
12. Volume down button
13. Volume up button
14. Power On / Battery Low / Charging icon
15. Visual level meter/Out-of-range icon
16. Speaker mute icon
17. Micro-USB port and power socket
• USB Cables power supply
RECEIVE LEVEL
NSMIT
ON
POWER
WER
PAIRING
3. Switch down the button
to ON (-).
1 m
Plugs not included
4. The power icon is flashing.
TRANSMIT
VOX ON
POWER
7