Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
1.1.
1.1.1.
1.1.2.
1.1.4.
2.
2.1.
2.1.1.
/
2.1.2.
2.1.3.
3.
3.1.
3.1.1.
3.2.
3.2.1.
3.2.2.
3.2.3.
3.3.
3.3.1.
3.3.2.
3.4.
4.
5.
5.1.
5.2.
,
5.3.
5.4.
V
5.5.
5.5.1.
5.5.2.
5.6.
5.7.
(
)
5.7.1.
5.7.2.
5.8.
-
5.9.
5.9.1.
5.9.2.
6.
520513.01
-
AM3 - AM55
17
17
17
17
Symbols are used in these instructions to help you understand them and to indicate particular points which you
18
need to act upon or consider. Those symbols are:
19
20
Reading symbol: to refer to the operator manual / instructions manual.
20
21
Warning symbol: This symbol means that failure to observe this point could lead to injury and
21
possibly damage to the machine. It serves as a special reminder about regulations and/or the correct
22
implementation of certain precautions.
22
Danger symbol: This symbol represents the DIN 4844 symbol (hazard warning); it warns of a hazard
22
which could result in death or injury, along with damage to the machine. This symbol must be
22
observed by all personnel working on this machine. Regulations on safety in the workplace must be
22
observed.
22
22
Environmental protection symbol: This symbol serves as a reminder to sort waste during
23
maintenance operations, to store it in a safe place, and to dispose of it with due care for the
23
environment.
23
24
Dustbin on wheels barred of a cross symbol: This symbol indicates that the equipment should not
25
be thrown with domestic waste and is subject to selective collection.
26
26
26
To ensure personal safety and to avoid any damage to equipment, it is essential to follow the
26
instructions contained in this document and any other documentation provided with the
27
device, and particularly the instructions on "Safe Practice".
27
27
For safety reasons any modification or alteration may be permitted only after having received the agreement of
28
the manufacturer.
28
If modifications are made without the prior agreement of the manufacturer all warrantees and manufacturers
29
responsibilities will be invalidated.
29
In these cases, the process for conformity evaluation pursuant to 2006/42/EC for all components may need to
29
be carried out again.
29
29
29
30
30
MEANING OF SYMBOLS USED IN THESE INSTRUCTIONS
16
Publicité
Chapitres
Table des Matières
Dépannage
