DeWalt D55153 Guide D'utilisation page 20

CODE POSSIBLE CAUSE
20 Extension cord is wrong length or gauge
21 Loose electrical connections
22 Possible defective motor or starting capacitor
23 Paint spray on internal motor parts
24 Fuse blown, circuit breaker tripped
25 Tank pressure exceeds pressure switch cut-in pressure
26 Pressure release valve on pressure switch has not unloaded
head pressure
POSSIBLE SOLUTION
Check for proper gauge wire and cord length. See Extension
Cords under Installation.
Contact a D WALT factory service center or a D
e
authorized service center.
Contact a D WALT factory service center or a D
e
authorized service center.
Contact a D WALT factory service center or a D
e
authorized service center.
in the paint spray area. See flammable vapor warning.
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for your particular
branch circuit.
2. Check for proper fuse. Use only a time delay fuse.
3. Check for low voltage conditions and/or proper
extension cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
Motor will start automatically when tank pressure drops below
cut-in pressure of pressure switch.
Set the On/Off switch to OFF. If the valve does not open,
replace switch. Contact a D
D WALT authorized service center.
e
20
WALT
e
WALT
e
WALT
e
Do not operate the compressor
WALT factory service center or a
e